Hello Everyone.
This is @alimtutorial, from #Bangladesh 🇧🇩
Assalamu Alaikum wa Rahmatullahi wa Barakatuhu
How are you all? I hope you are all doing well, I am also doing well by the grace of God. Today morning, when I woke up, someone said to press the tube well bucket suddenly opened. Then I sent my younger brother to the shop to get a new bucket. After my younger brother got a new bucket, I started the process of installing the bucket. So let me share with you how I installed the tube well bucket.
The process of installing a tubewell bucket
Required tools
Required tools
- Screwdriver
- Wrench
- Hammer
When I woke up in the morning, I first gathered all the tools to fix the tubewell. Everything I needed to do this job: a hammer, a screwdriver, a wrench, some bolts-nuts and washers, and of course a new bucket.
First, I started opening the old bucket. I lifted the handle of the tubewell and loosened the nuts under it with a wrench. Then I carefully took out the old bucket. Since it had been there for a long time, the old bucket was quite dirty.
I used a cotton cloth to seal the tubewell bucket tightly.
I saw that the bolt used to secure the tubewell bucket was used at the bottom, and after installing it, it moved again, so it seemed that the side of the bolt had worn out. Then I wrapped a cotton cloth over the bolt for a while to make it work properly, then I installed it well, then to tighten it further, I took a nut and slowly applied light pressure with the help of a hammer, and it became a little tight.
All Tubewell devices
Now the real work began. I took the new bucket in my hand and examined it carefully. Then I inserted the bucket into the tubewell pipe. You have to make sure that the bucket goes in straight. If it is crooked, then there may be a problem in raising the water later.
After placing the bucket in the right place, it is time to install the bolts and nuts. I secured the top of the bucket tightly with new bolts and washers. At this time, the wrench comes in handy. I tightened the nuts with the wrench in such a way that they do not come loose in any way. While tightening, you have to be careful not to put too much pressure, otherwise the nuts may break.
The inside of the tubewell
Once everything was installed, I put the tubewell handle on. Water came out after pumping once! When the job was successful, I felt really good. I felt like I had learned a lot by doing this small task.
| Device | Name | 💫 |
|---|
| Android | Redmi note 10 pro max | Smartphone |
| Camera | 108M | Quad_camera |
| Location | Bangladesh/Jamalpur | Our village |
| short by | @alimtutorial | me |
| Community | steem kids | and parents |
