You are viewing a single comment's thread from:
RE: My introduction to 3D design. About preparing a model for 3D printing
I find 3D creations fascinating as well. How is your experience with Blender? It looks a bit tough from my end. However, I found this software that gives me all the chills — Nomad Sculpt.
Blender also seemed too complicated to me at first, but gradually I got used to the interface until everything started to work properly. And many settings just get memorized over time, and in the end you realize that there’s nothing complicated there, as it seemed at the very beginning. I haven’t heard about the Nomad Sculpt software. Thank you, I’ll take a look.